Ender 3 Filament Guide Reddit. Snap in guide, many to choose from! The sub was started to be a good place to find information about anything related to the ender 3 from setup, to help with your prints, to showing off some of your creations.
Ender 3 Pro Filament Guide ender3 from www.reddit.com
If your printer hates to bridge, print end clip with support lines at 1.8mm apart (5 lines total under roof) only. End clip that wont fall out. If you wish to use a heated print plate, keep it between 60.
Full Rules Are In The R/Ender3 Rules Widget In The Sidebar Above This.
Please be friendly and helpful. Snap in guide, many to choose from! By thomroll sep 20, 2019.
Get It 3D Printed Source:
Message the mods before posting any sales links/affiliate links. By bzeuphonium jun 14, 2020. The base will fit tight but should not need any trimming, tested at a few resolutions.
If You Wish To Use A Heated Print Plate, Keep It Between 60.
Printables basics buyer's guides reviews deals. If your printer hates to bridge, print end clip with support lines at 1.8mm apart (5 lines total under roof) only. Additional settings or relevant information is.
Or If The Hole Is A Reasonable Size, Your Really Not Going To See Any Stress On The Filament.
The sub was started to be a good place to find information about anything related to the ender 3 from setup, to help with your prints, to showing off some of your creations. Message the mods before posting any sales links/affiliate links. Pla is rated the best filament for 3d printers.
Ender 3 Filament Guide With Pouley.
The filament does not require the print bed to be heated for it to adhere to the build plate. This is something i put together on tinkercad quickly to do that. Best filament for ender 3.
